# 4: Pi Scanner



After a week of refining my vulnerability scanner operating skills, I wanted to see if I could convert my Raspberry Pi into a semi-portable Nessus vulnerability scanner. Again, the Pi did not disappoint (I, by the way, do not work for Raspberry Pi). The most difficult aspect of the process was the amount of time it took the Nessus programme to load and finish assembling its plugins (around 1 hour and 20 minutes). 

 The right Nessus version for the Raspberry Pi was simple to locate and download from the Tenable website; I used the terminal to unpack, install, and launch the Scanner. The installation is done in a browser, and I enrolled for the Nessus Essentials licence.

After entering the activation code, it's off and running, well, more of a leisurely stroll; it did take a long time to get going, but it did. Then you must choose the type of scan you wish to perform and its target. I ran a simple scan on a laptop on my network and waited for the results. Surprisingly, just a few vulnerabilities were found, but that was only the basic network scan.


 

The Raspberry Pi had evolved into a high-quality vulnerability scanning solution.

Comments

Popular posts from this blog

# 9 : Cybersecurity Detection Home Lab: Installing Splunk

# 7: Say Goodbye to the Pi: Setting Up a Home Lab on a Budget

# 5: Why is it good to hire a former teacher?